Heidenhain ND 1200 Bedienungsanleitung PDF herunterladen (Seite 29)

ND 1200 QUADRA-CHEK 29

1.3 Preparing to Measure

Power-up the ND 1200

U Switch on the ND 1200. The POWER switch is located on the rear

of the enclosure. After switching the power on, or after a power

failure, the power-up screen will be displayed. See "Switching on the

ND 1200" on page 16.

U Press the FINISH key to advance from the power-up screen to the

DRO.

If your ND 1200 was configured to establish a machine zero upon

powering up, a message will be displayed asking you to cross

reference marks or specify axis references manually.

Establish machine zero

A repeatable machine zero is required if you plan to retain feature

measurement results across a power cycle or if error correction will be

applied to your measurements.

To establish a repeatable machine zero:

U Move the stage to have reference mark crossings recognized on

each axis or

U move the stage to the hard-stop reference position and press

ENTER on each axis when no encoder reference marks are present.

Often feature data retention and error correction are not

desired. In these cases, it is not necessary to establish a

machine zero.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 140 141

Keine Kommentare

Heidenhain ND 1200 Bedienungsanleitung Seite 29