Heidenhain CNC Pilot 4290 Bedienungsanleitung PDF herunterladen (Seite 155)

HEIDENHAIN CNC PILOT 4290

143

4.9 Drilling Cycles

4.9 Drilling cycles

Simple drilling cycle G71

G71 is used for axial and radial bore holes using driven or stationary tools.

The cycle is used for:

■ Individual bore hole without contour description

■ Bore holes with contour definition (individual bore hole or hole

pattern) in the following program sections:

■ FRONT

■ REAR SIDE

■ SURFACE

The type of drill determines when a feed rate reduction begins:

■ Indexable inserts and twist drills with 180° drilling angle:

Reduction at end of hole – 2 * safety clearance

■ Other drills:

Drill end – length of first cut – safety clearance

(length of first cut=drill tip; safety clearance: see machining

parameter 9 ”Drilling” or G47, G147).

Parameters

NS: Contour block number with geometry of bore hole (G49, G300/

G310-Geo) – no input: Individual bore hole without contour

definition

X, Z: Position, length – end point of axis/radial holes (X diameter

value)

E: Period of dwell in seconds (for chip breaking at end of hole) –

default: 0

V: Feed rate reduction (50%) – default: 0

■ V=0 or 2: Reduction at start

■ V=1 or 3: Reduction at start and at end

■ V=4: Reduction at end

■ V=5: No reduction

Exception with V=0 and V=1: No reduction when boring when

indexable insert drills and twist drills with 180° drilling angle are

used

D: Retraction speed – default: 0

■ D=0: Rapid traverse

■ D=1: Feed rate

K: Retraction plane (radial holes, holes in the YZ plane: diameter) –

default: to starting position or to safety clearance

Cycle run

1 Bore hole without contour definition

Precondition: Tool is located at the safety distance

from the bore hole (”starting position”).

Bore hole with contour definition:

The tool approaches the starting position at rapid

traverse:

■ If K is not programmed: Approach to clearance height

■ If K is programmed: Approach to K, and then to

clearance height.

2 Start drilling bore hole – feed rate reduction

according to ”V.”

3 Drill hole at feed rate.

4 Drill through – feed rate reduction according to ”V.”

5 Retract at rapid traverse or feed rate according to

”D.”

6 Position to which the tool retracts:

■ If K is not programmed: Retraction to the starting

point

■ If K is programmed: Retraction to position K

■ Single hole without contour description:

Program „X or Z“ as alternative.

■ Hole with contour description: Do not

program X, Z.

■ Hole pattern: NS refers to the bore hole

contour (and not the definition of the pattern)).

1 2 ... 150 151 152 153 154 155 156 157 158 159 160 ... 480 481

Kommentare zu diesen Handbüchern

Keine Kommentare

Heidenhain CNC Pilot 4290 Bedienungsanleitung Seite 155

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Ausrüstung Heidenhain CNC Pilot 4290